Schoeps RS 420 C Tube with gooseneck element for Colette, 42cm
These goosenecks are used directly between capsules and amplifiers of the Colette series. For mounting in a table top, the AF 1 flange (not included) offers good isolation from solid-borne noise. Mounting is generally quite straightforward and simple.
A CUT 1 or CUT 2 variable low-cut filter can be used on the amplifier – though the filter does not fit into the AF 1, so it would have to “ride“ above the table top.
- special long (420 mm) gooseneck
Application
First, fasten the two AF 1s securely, one precisely above the other, to the lectern or table top. Then screw the gooseneck onto the 3/8'' threads at the end of the ST 20-3/8 cylinder. Push the XLR connector of the output cable through the AF 1s and press the cable into the groove in the side of the cylinder. Finally, insert the cylinder (with the output cable now attached) into the AF 1s.
With the RS 420 and SRS 420 goosenecks, two AF 1 flanged mounting adapters should be used for stability, one above the other, with both holding the microphone amplifier (e.g. CMC).
Specifications
| RS 420 Cg, SRS 420 Cg |
| Length |
RS 420 Cg: 420 mm, (rigid part: 317 mm)
SRS 420 Cg: 420 mm, (rigid part: 257 mm) |
| Diameter |
RS: 8 mm, SRS: 6,4 mm and 8 mm |
| Surface finish |
matte gray (g) |
Other lengths or versions (e.g. older SKC models) are available on request.
Distributed Brands
